Ohm's Law Calculator
Solve voltage, current, resistance, and power from any two independent values.
Choose a tool, enter your values, and see the equation and assumptions behind the result.
Solve voltage, current, resistance, and power from any two independent values.
Choose a standard current-limiting resistor and check its actual current and power.
Compare unloaded and loaded output voltage, current, and resistor power.
Analyze monostable pulses and astable oscillators, reverse-design timing components, and plot the ideal output timing.
Analyze non-inverting, inverting, summing and difference amplifiers; select E24 feedback resistors and compare ideal output with your rail/headroom limits.
Combine 2–10 ideal capacitors and calculate equivalent capacitance, total charge, stored energy and the voltage across each part.
Find capacitive/inductive reactance, complex series or parallel RLC impedance, phase, resonance and current from an RMS sinusoidal source.
Set an LM317 output with E24 feedback resistors, or estimate LDO headroom, efficiency, power and temperature.
Select an E24 base resistor for a low-side NPN switch using forced beta and a driver-current limit.
Estimate conduction and overlap switching loss, gate-driver demand, and a first-pass junction temperature.
Estimate half-wave or bridge rectifier ripple and DC output, or select an E12 smoothing capacitor.
Check ideal ADC resolution, a sensor input divider and code bins, or convert NTC resistance and temperature.
Analyze 2–10 resistors in series, parallel or grouped mixed expressions. Add a supply voltage for branch current, voltage and dissipation.
Explore capacitor charging and discharging with an RC curve, initial voltage, time constant, and the time needed to reach a target voltage.
Decode 4-band and 5-band resistor colors, or turn a resistance into bands. See the nominal value, tolerance, and minimum and maximum resistance.
Decode 3-digit, 4-digit, R-decimal, and EIA-96 resistor markings. See the lookup value and multiplier without guessing an unknown marking system.
Decode three-digit capacitor codes such as 104 and 222, or convert between pF, nF, µF, and F. See the calculation and the limits of the marking.
Find standard resistor pairs for a target voltage, with load resistance, a source-current budget, and a nominal error limit. Compare five ranked designs.
Approximate a target resistance using up to four standard resistors in series, parallel or supported mixed arrangements. Compare E12/E24 combinations, equivalent values, and errors.
Calculate RC cutoff, gain, phase, and frequency-response plots. Reverse-design R or C for a target cutoff, then check the actual standard-value result.
Check divider, LED, ideal RC and op-amp gain tolerances. Compare worst-case ranges with seeded independent uniform Monte Carlo samples.
Find real, apparent, and reactive power from voltage, current, power factor, and phase.
Estimate resistive voltage drop for a copper or aluminum run using metric conductor area.
Estimate primary and secondary full-load current from rated kVA and voltages.
Estimate energy use and cost from load power, daily runtime, days, and your tariff.
Planning a US wiring run? Read worked wire and conduit examples →
Choose a conductor size from ampacity and voltage drop.
Check a known AWG against a voltage-drop target.
Check conductor fill for EMT or PVC conduit.
Look up planning values for copper and aluminum conductors.