Tool Disclaimer
Last updated: 2026-11-19.
Calculators and experiments on this site use simplified models for learning and early planning. Values are estimates, not substitutes for exact component datasheets, direct measurements, applicable electrical rules, or qualified design review.
Calculator limits
The LED resistor calculator assumes a fixed LED forward voltage. Actual forward voltage and current change with temperature and device variation. The loaded divider experiment models ideal DC resistors in a fixed topology; it does not solve arbitrary circuits or transient behavior.
The AC power and transformer current tools use nominal, balanced conditions. The metric wire voltage-drop tool uses a simplified resistive model at about 20 °C. Real systems can differ because of power factor, temperature, reactance, connections, and installation conditions. The energy-cost estimate uses a constant load and a flat tariff supplied by you.
The retained NEC planning tools have their own assumptions. Verify any installation against current applicable code, manufacturer instructions, and the authority having jurisdiction. A calculated output is not code approval or an engineering stamp.
Free wiring lab
CircuitJS uses numerical component models and time steps. Floating nodes, ideal-source shorts or unstable circuits can prevent a solution. A simulated circuit does not establish physical component ratings, safe construction or manufacturing performance. The software is supplied without warranty under its applicable open-source licences.
Contact
Found a problem or have a suggestion? Use the form below or open the feedback page.
Checking your sign-in…